Skip to main content

Liebherr crawler crane helps modify cooling tower at Weisweiler power plant

Published by
World Coal,


A Liebherr LR 1600/2 crawler crane was in action completing modification work in one of the cooling towers at Weisweiler power plant in North Rhine- Westphalia. Crane and heavy haulage logistics contractor Wasel, based in Bergheim near Cologne, received an order to replace parts of the pipework system over the top edge of the massive cooling tower. The crane was erected with an impressive roller head height of 182 m to carry out this job.

Liebherr crawler crane helps modify cooling tower at Weisweiler power plant

3 days and 54 low loader journeys were required to erect the enormous crawler crane between the two cooling towers at the lignite power plant. Set up with its main 102 m boom and a 78 m luffing fly jib, the Liebherr crane hoisted the glass fibre-reinforced plastic components weighing up to 12 t out of the power plant’s 117 m high tower. The LR 1600/2 had to handle radii of up to 61 m in the process. In fact, the Liebherr crawler crane required around half of the total of 525 t of ballast used for the job just to raise and lower its impressively long lattice boom. The pallet with the suspended ballast was generally not required for the actual crane work. An additional 60 t of ballast were used on the derrick boom for hoists involving a large radius.

There was no alternative to using the route over the opening in the internally hollow concrete body to replace the awkward components that make up the clean gas pipework. It was not possible to replace the pipe components using the only access point to the tower at a height of around ten metres as a result of their massive dimensions.

Read the article online at: https://www.worldcoal.com/power/16092019/liebherr-crawler-crane-helps-modify-cooling-tower-at-weisweiler-power-plant/

You might also like

 
 

Embed article link: (copy the HTML code below):


 

World Coal is not responsible for the content of external internet sites.